Inserting SIMMs
Make sure the computer is turned off and the cover is off. Then
follow these steps to install SIMMs:
1.
Refer to the illustration on page 3-6 to locate the SIMM
sockets on the right side of the system board, next to the
power supply connector.
2.
You need to remove the rear internal drive bay bracket to
access the SIMM sockets. (If there is a drive mounted in this
bracket, you’ll need to remove it first; see Chapter 4 for
instructions.) Remove the four screws that hold the bracket
to the back of the system, as shown below.
3.
Rest the computer on its side, so that the system board is flat
and the components on the board are easy to reach.
Installing and Removing Options
3-11
Содержание ActionTower 2000
Страница 1: ......
Страница 15: ...Glossary Index EPSON U S and International Marketing Locations V l l l ...
Страница 87: ...4 20 Installing and Removing Drives ...