Paper Handling
41
User’s Guide
B
Release the paper lever while holding the
paper to remove it from the printer.
Using Auto Take-up Reel Unit
When you want to print your data on roll paper
and do not want to cut it or feed it out onto the
floor, you can use this Auto Take-up Reel Unit to
roll up your print.
You can wind the roll paper forward or
backward.
Make sure that the leading edge of the roll paper
is straight; otherwise, it does not take up the roll
paper correctly.
See “Using Roll Paper” on page 29.
Winding paper forward
A
Set the paper guides to the forward
position.
B
Make sure the orange sensor light is on.
The green sensor light indicates that the
Auto-Take up Reel Unit is on.
If the orange sensor light is off, there is an
obstacle between the light detector and
light emitter, or the alignment of these
devices is not correct. Adjust the direction
of the light emitter so it is aligned with the
light detector, and turn the dial to lock the
light emitter.
C
Press the
button to select Roll Auto Cut
Off .
Auto Take-up Reel Unit winds the roll
paper only when Roll Auto Cut Off
is
selected.
D
Align the roll paper edge with the
horizontal line of the roll paper set position.
The barcode is scanned when it is printed
on the roll paper edge. Then press the
button to feed the roll paper.
c
Caution:
When you release the paper lever, the
paper may fall. Be sure to hold the paper
to avoid falling and damaging the paper.
w
Warning:
Make sure the take-up reel unit is installed
properly and securely. Bodily injury may occur
if it falls.
