2. Installation and Getting Started
Quick Installation
Install Guide
Page 11
3
Power on the VGA Bridge devices by connecting the supplied
power adapters.
• The VGA Bridge devices start up and get IP addresses from
the DHCP server on the Ethernet LAN.
• The VGA Bridge device connected to the VGA or DVI
source becomes a
transmitter
and looks on the network for
a VGA Bridge operating as a receiver.
• The VGA Bridge device not connected to a VGA or DVI
source becomes a
receiver
and looks on the network for a
VGA Bridge functioning as a transmitter. As the receiver
starts up, it may display startup sequence messages on the
monitor or projector. When the receiver begins receiving
images from the transmitter, the images are displayed on
the monitor or projector.
Figure 6: Location of the VGA Bridge power connector
Troubleshooting
If images are not displayed on the monitor connected to the
receiver, check the following:
• Make sure both VGA Bridge devices are connected and
operating as described in this section.
• Make sure the VGA or DVI source is connected to the VGA
Bridge transmitter INPUT port and producing images. To
verify that the VGA Bridge transmitter is receiving images
from the VGA or DVI source, connect a VGA or DVI monitor
to the transmitter OUTPUT port. If the monitor displays
images the transmitter is receiving images from the VGA or
DVI source.
Power
