![background image](http://html.mh-extra.com/html/epiphan/vga-bridge/vga-bridge_install-manual_2417807011.webp)
2. Installation and Getting Started
Software Features
Install Guide
Page 15
Software Features
Use the following software features to install the VGA Bridge
device on the network.
LED
startup
sequence
Green and blue LEDs. When the VGA Bridge
device first starts up, the blue LED lights up. A few
seconds later the green LED lights up. After about
another 20 seconds the blue LED turns off, leaving
the green LED on indicating that the VGA Bridge
has started up and can start capturing images.
During operation the blue LED blinks during VGA
signal test operation and when the system tunes
VGA parameters.
Red LED
During operation the red LED blinks each time the
VGA Bridge captures an image. You can use the
red LED as an indicator that the VGA Bridge device
is capturing images.
Default IP
address
and
network
mask
IP:
192.168.255.250
Netmask:
255.255.255.252
User Name:
admin (no password)
IP
address
from a
DHCP
server
A VGA Bridge device can get an IP address on the
network from a DHCP server if the network has
one. If the device gets an IP address from a DHCP
server, you can see the IP address by running the
network discovery utility to find the device on the
“Using the Network Discovery Utility
to Find the IP Addresses of VGA Bridge Devices”
.
If the network does not have a DHCP server, see
the Network Does Not Have a DHCP Server” on
.