epiphan KVM2Ethernet, Руководство пользователя

Страница: 126 / 188

6. Web admin interface If the Network Does Not Have a DHCP Server
Page 126 VGA2Ethernet
Restoring the factory configuration can also help with
troubleshooting. If after making a number of configuration
changes you notice problems and you are not sure which change
is causing the problems, you can restore the Factory
Configuration and start over.
Note: The factory default configuration sets the device to get an
IP address from a DHCP server.
If the Network Does Not Have a DHCP
Server
If the network does not have a DHCP server, you need to log into
the Web admin interface to change the device IP address. To do
this you need to temporarily change the network configuration of
the video capture workstation.
You must also establish an Ethernet connection between the
VGA2Ethernet or KVM2Ethernet device and your PC. To do this
use one of the following:
• Connect the Eth 1 port to the same Ethernet network as the
video capture workstation.
• Connect the Eth 1 port to an Ethernet network switch and
connect the video capture workstation Ethernet port to the
same switch.
• Connect the Eth 1 port directly to the video capture
workstation Ethernet port. (You can use a regular or cross-
over Ethernet cable for this connection.)
To log into the Web admin interface
1 Change the IP address of the video capture workstation to:
IP Address: 192.168.255.249
Subnet Mask: 255.255.255.252
Follow the instructions for your operating system. If the
operating system supports adding more than one IP address,
then you can add this IP address as a second IP address
instead of changing the current address.