Epec 4W30, Инструкция по эксплуатации

Страница: 37 / 73

Instructions for use Epec 4W30 36
(C) Epec Oy Seinäjoki Finland
7.37 Tilt Down (K46)
−
The setting of whether the tilt down function is carried out manually
or automatically, after the felling sawing.
−
If the automatic tilt down is valid, then the tilt is lowered always after
the felling sawing. If the manual tilt down is valid, then the tilt is not
lowered until the key "Tilt down" is pressed.
−
Setting range 0 – 2:
0 = manual tilt down
1 = automatic tilt down (activates after the tree is cut, i.e. when
sawbar starts its return to the casing)
2 = automatic tilt down (activates when sawbar leaves the casing)
7.38 Tracks Delay (K47)
−
When closing the grapple, the delimbing knives are closed first. After
that, the tracks are closed. With this setting is set time delay between
the closing of the delimbing knives and the closing of the tracks.
−
Tree will not be placed properly to the grapple, if tracks delay is too
short.
−
The setting range is 0 – 1 seconds.
7.39 Selection of Measurement System (48)
−
Selection of the measurement system which is used in the measuring
equipment. The metric system’s units are millimetre, centimetre and
metre. The imperial system’s units are inch and foot.
−
When using the imperial system, length is given in feet and inches.
Diameter is given in inches and 1/16 inches. Cubics are given in
Cunit s. Also the preselection data, the data of the printout window,
and the Pieces printout is displayed in imperial units.
−
Measuring equipment converts the units as follows:
10 millimetres = 1 centimetre
100 centimetres = 1 metre
1 inch = 25,4 millimetres
1 foot = 305 millimetres
12 inches = 1 foot
1 Cunit = 100 cubic feet
1 cubic metre = 0,353 Cunit
−
0 = metric system in use, 1 = imperial system in use.