Epec 4W30, Инструкция по эксплуатации

Страница: 25 / 73

Instructions for use Epec 4W30 24
(C) Epec Oy Seinäjoki Finland
6 PROGRAMMING OF PRESELECTIONS
1. Open the grapple. Then press the preselection key, the data of which
you want to change, for 4 seconds.
2. The preselection data is changed into the data programmed for that
key, and this data is displayed.
3. Select the data to be changed with the programming wheel and
activate the change with Enter. When data is being changed, the
display of this data is shown in black background.
4. Acknowledge or cancel the change by pressing Enter or Cancel.
5. The programming mode is deactivated by pressing Cancel.
NOTE!
If pieces have been made to the preselection, the tree species or the
length of such preselection cannot be changed. In that case, the
changes has to be made when changing the job number (setting number
1).
−
Number ranges of the data:
1. Tree species , range 1 – 12.
2. Wood type , range 0 – 9.
3. Length , range 50 – 3000 cm.
4. Tolerance , range 0 – 99 mm. The length tolerance is the
accepted length deviation from the desired length. If the
tolerance setting is for instance 30 mm, the length of a 4.6 m
log can vary 4.570 m – 4.630 m.
5. Top minimum diameter , range 0 – 999 mm.
−
If you want to, you can change the names of the tree species and the
names of the wood types, and save them to the measuring
equipment's memory. Detailed information is found in enclosure "3.
Names of tree species and wood types".
Tree
species Length Tolerance Top minimum Wood
type
Change of data of preselection /
preselection key active. The tree
species is being changed. This mode
is activated by pressing the desired
preselection for 4 seconds when the
grapple is open.
The name of the tree species can be
selected among 12 possible names and
the name of the wood type among 9
possible names.