EP Equipment IMOW ICE251, Руководство по эксплуатации

Страница: 74 / 95

67
Error Message
Possible cause Fault elimination
Error
Error text
224
WAITING FOR
NODE
The controller receives from the
CAN bus the message that another
controller in the net is in fault
condition; as a consequence the
controller itself cannot enter
into an operative status, but it has to
wait until the other node comes out
from the fault status.
Check if any other device on the
CAN bus is in fault condition.
66 BATTERY LOW
The battery charge is evaluated to
be lower than 10% of the full charge
and the BATTERY CHECK setting
is other than 0 (refer to SET
OPTION menu).
- Check the battery charge and
charge it if necessary.
- If the battery is actually charged,
measure the battery voltage
through a voltmeter and compare
it with the value in the BATTERY
VOLTAGE reading in the
TESTER function. If they are
different, adjust the ADJUST
BATTERY parameter with the
value measured through the
voltmeter.
- If the problem is not solved,
247
DATA
ACQUISITION
Controller in calibration state.
The alarm ends when the
acquisition is done.
249
CHECK UP
NEEDED
This is a warning to point out that it
is time for the programmed
maintenance. Turn on the CHECK UP DONE
option after that the maintenance
service.