EP Equipment IMOW ICE251, Руководство по эксплуатации

Страница: 15 / 95

8
Warning!
Before open the key switch to press the accelerator pedal, the more function digital
indicator shall show alarm information. Then you must release the accelerator
pedal.
When loosen the accelerator pedal, truck can make soft brake because of electric
control’s regenerate brake.
Warning!
The tilt lock mechanism built in the hydraulic control valve does not
allow the mast to tilt forwards while the engine is being shut down
even if the tilt lever is pushed forwards.
1.3.6 Levers
/buttons
Lifting lever/button [18]
The forks can be raised or lowered by pulling backwards or pushing the
lever. Lifting speed can be controlled by tilt backwards angle of lever while
the lowering speed can be controlled by tilt forwards angle of the lever.
(The forks can be raised or lowered by pressing the lifting button or the
down button.)
The motor speed or accelerator pedal does not have to do with the
lowering speed of the forks.
Tilting lever/button [19]
The mast can be tilted by operation of this tilting lever. Pulling on this lever
backwards will tilt the mast backwards, and pushing it forwards will tilt the
mast forwards. The tilt speed can be controlled by tilt angle of the lever.
(The mast can be tilted by pressing the button.)
Side lever/button[20]
The fork can be move to side by operation of this lever. The move speed can be
controlled by tilt angle of the lever.
You don't have the lever, when you truck use two unite valve.
1.3.7 Pedal
Brake pedal [25]
Press this pedal to slow or stop the
truck. At the same time, the brake light
comes on.
Accelerator pedal [24]
As the accelerator pedal is slowly pressed, the drive motor start turning and the forklift
truck will start to move. According to the force applied to the pedal, the speed is
adjusted with not steps.
Warning!
No permitted to press the brake pedal
and the accelerator pedal at one time,
otherwise, it should harm the traveling
motor.