3
1
2
3
4
5
6
7
8
10
min.
1. Installation of the control unit
Before the control unit can be fastened to
the outer wall of the cabin, the covering of
the control unit must be removed. For this,
the two mounting screws (Illust. 1) are
loosened. These screws are attached
beneath the control panel dials as captive
screws, but may be screwed open and
closed through the visible holes in the
operating panel with a small Phillips
screwdriver. After the screws are loosened,
the cover is removed.
For practical purposes, the control unit
should always be fastened to the outer wall
of the cabin near the sauna control unit.
If this is desired, please observe that most
sauna cabins have already been equipped
with cable conduits for electrical wiring; in
this case, the position of the control unit is
pre-determined. For the mounting of the
control unit, the mounting holes Æ 3 are
drilled in accordance with the dimensions
given in Illust. 3, and one of the provided
wood screws 4 x 20, see Illust. 3.1, is
screwed into the wood through the upper
middle hole, leaving a 3mm section of the
screw projecting out from the wall. The
lower part of the control unit is hooked onto
this wood screw by its upper mounting hole.
Finally all connecting lines - see Illust. 4 -
are conducted through the respective feed-
through channels into the control unit
.
Illust. 1
Illust. 2
The colored light control units are delivered equipped for a voltage of 230 V 50 Hz
as a standard and must be separately fuse protected against 10 A.
Installation and connection of the sauna systems and other electrical
equipment may be undertaken only by a expert; this is subject to VDE 0100,
Part 703/2006-2
Sauna systems may be connected to the power supply only by hard wire.
For trouble-free operation of your sauna system, please read the following
installation and user's guide thoroughly.
mounting screws
Control buttons
Supply line
color lighting
Control unit
Colored light unit
english
