Envirovent energisava250, Руководство по установке

Страница: 14 / 20

SHOULD YOU ENCOUNTER ANY PROBLEMS INSTALLING THIS UNIT CALL
0345 27 27 810
13
Setup guide for the energiSava 250
The control switch is found behind the rear
cover panel.
Commissioning mode is chosen by pressing
the SET button for 4 seconds, all sensor
inputs will be disabled in this mode so that
they do not interfere with flow rates. All LEDs
will light with the Extract Boost flashing
(Ext B), this indicates that the flow rate may
now be increased/decreased as required.
The next press of the SET button will move
commissioning to the next setting, Sup.B
and so on. When the unit has been fully
commissioned, press the SET button for 4
seconds and this will put the unit back into
status mode. If the unit is not put back into
status mode after commissioning, it will
automatically revert back to status mode
after an hour.
Note: Settings will be retained if the power
supply is interrupted.
07 Commissioning Part 2
LED Indications
Constant LED Flashing LED
(A) Frost protection ON
(B) Boost state -
Humidity ON
(C) Boost state -
Switched input ON
(D) Summer by-pass ON
(A) Service required
(B) Service required
(C) N/A
(D) Check filter*
Supply and extract LED indications
Commissioning mode only
*To reset filter indication, see maintenance
section on page 16.