Installation, Start-Up, Adjustment and Maintenance Manual
68
Omni Waste Oil Chiller
Limited Warranty
Enviro
Heat (manufacturer) warrants to the purchaser of waste oil chiller will be free from defects in
materials and workmanship for the durations specified below, which duration begins on the date of
delivery to the customer. Customer is responsible for maintaining proof of date of delivery.
If return is deemed necessary for warranty evaluation and determination of repair or replacement,
chiller is to be sent to the factory with freight prepaid.
Enviro
Heat reserves the right to determine
appropriate action for repair or replacement.
No parts will be accepted by
Enviro
Heat without RA# (return authorization number) clearly marked on
outside of shipping package. Obtaining RA# requires model and serial numbers, description of part
being replaced and nature of defect. Call factory to receive RA#.
Warranty Covers:
Air Cooled Absorption Water Chiller
1.
Three Years full repair or replacement (Parts Only)
Waste Oil Burner and Combustion Chamber
1.
Combustion Chamber and Heat Exchanger five (5) years *full repair or replacement,
additional five (5) years prorated. (Parts Only)
2.
Oil Heater Block, twenty (20) years. (Part Only)
3.
Oil Heater Block Controller PCB, three (3) years. (Parts Only)
4.
All other components, one (1) year. (Parts Only)
This warranty is void if:
1.
Warranty registration card is not returned within thirty (30) days of purchase.
2.
Any part or component subject to abuse or altered from original manufactures specifications.
3.
Installation not in accordance with instructions.
4.
Has not been properly maintained, operated or has been misused.
5.
Wiring not in accordance with diagram furnished with chiller.
6.
Chiller is operated in the presence of chlorinated vapors.
Warranty is limited to the original purchaser.
The above warranty is in lieu of all other warranties expressed or implied.
Enviro
Heat does not
authorize any person or representative to make or assume any other obligation or liability that is not in
accordance with above warranty.
Enviro
Heat is not responsible for any labor cost unless prior
authorization in writing has been obtained.
NOTE: Combustion Chamber Warranty
is specific to material and workmanship. Workmanship
means
Enviro
Heat warranties the welds are good and will hold. Material means they won’t corrode
through due to sulfur in the ash that accumulates during operation. Warranty does not apply to units
that experience overheating stress cracks. These are not incurred because the materials are
inadequate for the application nor are they a result of a weld broke lose because of bad penetration.
Which is easily recognized by the material being left underneath the weld. These cracks occur as a
direct result of improper draft, either by inadequate initial installation and setup which requires (1)
establishing a proper draft during installation (2) back draft has occurred due to ash buildup, backing
up hot gas passageways either in the exchangers, the stack, or both. (3) Over firing by setting oil
supply pressure too high (see manual for proper setting) these are all cases of thermal overload.
*
Under normal use only. If misuse or abuse is deemed apparent after inspection, warranty is void.
