Enviro VB09-36, Установка, эксплуатация и обслуживание, Страница: 5 / 40

FORM ET145.18-IOM1 (115)
ENVIRO-TEC 5
G. The compressor is mounted on neoprene isolators with
metal spacing sleeves inside and secured with nuts,
which must be snug against the metal spacer sleeves.
H. Inspect all electrical connections. Connections must be
clean and tight at the terminals.
DO NOT USE THE RISERS TO LIFT THE CABINET
ASSEMBLY!
DO NOT install this unit outdoors.
A compressor/unit comprises a pressurized
system. Never Loosen threaded joints while the
system is under pressure and never open
pressurized system parts.
Before servicing, open and tag all disconnect
switches.
Do not install units in a flammable environment due
to the danger of an explosion.
Safety guards, shields, barriers, covers and
protective devices must not be removed while the
compressor / unit is operating.
All safety features, disengagement and interlocks
must be in place and function correctly before the
equipment is put into operation. Never by-pass or
wire around any safety device.
Use gloves and protective goggles and where
appropriate, make sure to have a gas mask close at
hand. Also use electrical protection equipment and
tools suited for electrical operation purposes.
Personnel must be qualified according to national
safety rules and regulations.
The system should be installed by manufacturer-
qualified personnel. If not, it may cause water
leakage, electric shock or fire.
E. Rigging
Follow all applicable regulations and safety practices during
rigging and lifting. Prepare and follow written rigging and lifting
plan. Lifting must be directed by trained professional rigger.
Spreader bars must be used and be long enough to prevent
rigging from contacting unit. Use all and only designated lift
points according to unit's Manual(s). Locate center of gravity
through trial lifts to account for possible variations in unit
configuration. Use rigging and lifting techniques that keep unit
stable and level. Keep clear of unit when lifted.