Enviro Meridian Cast Iron, Руководство пользователя

Страница: 28 / 40

Routine Cleaning and Maintenance
Figure 33: Firebox Components Removal.
sliding them forward then out.
• Pull the center panel out.
• Vacuum and clean thoroughly.
Installation of firebox backing:
• Insert center panel with backing.
• Place the two (2) side panels back
into the firebox and reinstall the
two (2) retainers using two (2)
screws on each side.
• Replace the burn pot and burn
pot liner
• Close the firebox door and
secure. Then close the cast door.
POST SEASON CLEAN-UP
Once you are finished using the
pellet appliance for the season,
unplug the stove for added electrical
protection. It is very important that
the stove be cleaned and serviced
as stated above.
EXHAUST PASSAGES
(season)
Removal of the firebox backing for bi-annual cleaning (refer to Figure 33):
• Open the front cast door
• Open the firebox door by lifting the handle, remove the burn pot and burn pot liner.
• Lubricate all screws with penetrating oil.
• Remove the four (4) screws that hold the steel liner retainers in place. Remove side steel liners by
CLEANING PAINTED SURFACES
Painted surfaces should be wiped with a damp cloth periodically. Never clean surfaces when they are
hot. Do not use other cleaners or abrasives as they may leave a residue or scratches, which can become
permanently etched into the surface.
FIREBOX PANEL
The paint on the steel firebox panels may peel. This is due to extreme conditions applied to the paint and
is in no way covered by warranty.
REPLACING DOOR GLASS
It is recommended that your ENVIRO dealer replace the glass if broken.
The door glass is made of high temperature PYRO CERAMIC 5 mm thick. The center panel is 15.4” x 9.0”
(39.0 cm x 22.9 cm) and side panels are 2.6 x 9.0 inches (6.7 cm x 22.9 cm). They must be replaced with
(Part # EF-062). Substitute materials will not be permitted.
28