background image

4

Introduction

i

mPoRtant

 S

afety

 D

ata

:

Please read this entire Owner’s Manual before installing or operating your ENVIRO Pellet 

Stove.  Failure  to  follow  these  instructions  may  result  in  property  damage,  bodily  injury 

or even death. Contact your local building or fire official to obtain a permit and any information on 

installation restrictions and inspection requirements for your area.
To prevent the possibility of a fire, ensure that the appliance is properly installed by adhering to the 

installation  instructions.  An  ENVIRO  dealer  will  be  happy  to  assist  you  in  obtaining  information  with 

regards to your local building codes and installation restrictions.
Be sure to maintain the structural integrity of the home when passing a vent through walls, ceilings, or 

roofs.
The stove’s exhaust system works with negative combustion chamber pressure and a slightly positive 

chimney pressure. It is very important to ensure that the exhaust system be sealed and airtight. The ash 

pan and viewing door must be locked securely for proper and safe operation of the pellet stove.
Do  not  burn  with  insufficient  combustion  air.  A  periodic  check  is  recommended  to  ensure  proper 

combustion air is admitted to the combustion chamber.  Setting the proper combustion air is achieved by 

adjusting the slider damper located on the left side of the stove.
When installing the stove in a mobile home, it must be electrically grounded to the steel chassis of the 

home and bolted to the floor.  Make sure that the structural integrity of the home is maintained and all 

construction meets local building codes.
Minor soot or creosote may accumulate when the stove is operated under incorrect conditions such as an 

extremely rich burn (black tipped, lazy orange flames).
If you have any questions with regard to your stove or the above-mentioned information, please feel free 

to contact your local dealer for further clarification and comments.

S

afety

 W

aRningS

 a

nD

 R

ecommenDationS

:

Caution: Do not connect to any air distribution duct or system.

Do not burn garbage or flammable fluids such as gasoline, naptha or engine oil.

Unit hot while in operation. Keep children, clothing and furniture away. Contact 

may cause skin burns.

FUEL:  This pellet stove is designed and approved to only burn wood pellet fuel with up to 3% ash 

content.  Dirty fuel will adversely affect the operation and performance of the unit and may void the 

warranty. Check with your dealer for fuel recommendations.   

 

THE USE OF CORDWOOD IS PROHIBITED BY LAW.

SOOT: Operation of the stove with insufficient combustion air will result in the formation of soot which 

will collect on the glass, the heat exchanger, the exhaust vent system, and may stain the outside of the 

house. This is a dangerous situation and is inefficient. Frequently check your stove and adjust the slider/

damper as needed to ensure proper combustion. See: “

S

LiDeR

/D

amPeR

 S

etting

”.

CLEANING: There will be some build up of fly ash and small amounts of creosote in the exhaust. This 

will vary due to the ash content of the fuel used and the operation of the stove. It is advisable to inspect 

and clean the exhaust vent semi-annually or every two tons of pellets.

Содержание MERIDIAN-A















Отзывы: