9
Operating Instructions
Operating Instructions
n
oRmaL
s
ounDs
D
uRing
o
peRation
:
Component
Sound & Reason
Fire Box
Creaking when heating up or cooling down.
Burner
Light pop or poof when turned off; this is more common with LP units.
Pilot Flame
Quiet whisper while the pilot flame in on.
Blower / Fan
Air movement that increases and decreases with the speed of the blower.
Gas Control Valve
Dull click when turning on or off, this is the valve opening and closing.
IFC
Beeps when remote control buttons are pressed.
Table 4: Normal Sound
V
entuRi
a
Djustment
:
R
emote
c
ontRoL
o
peRations
:
The Proflame 2 GTMFLSA is a modular remote control system that directs the functions of the EX32.
The Proflame 2 GTMFLSA is configured to control the on/off main burner operation, its flame levels and
provides on/off and Smart thermostatic control of the appliance. The system controls a remotely actuated
top light, as well as bottom lights and fan speed each through six (6) levels.
Warning:
Incorrect venturi adjustment may lead to improper combustion, which is a safety hazard.
Contact the dealer if there is any concern about the venturi adjustment.
Figure 4: Adjusting the venturi air setting.
The venturi adjustment lever is located on the right side of the unit, below the door (see Figure 4).
The venturi allows the amount of air coming into the fireplace to be adjusted in order to accommodate
different climates and venting arrangements. Start the pilot and then the burner. Make sure the pilot
flame is burning normally and none of the burner ports are plugged. Let the fireplace burn for roughly
fifteen (15) minutes and then examine the flames. The ideal flame will be blue at the base and light
orange above. The flames should be of medium height. If
the flames look like this, no venturi adjustment is needed.
If the flames are fairly short and mostly blue, the fireplace
is getting too much air. Therefore, the air shutter should
be closed (push left) slightly until the correct flames are
achieved. Flames that are very orange, with tall dark
stringy tips are not getting enough air. Open (push right)
the venturi until the flames clean up. If the venturi is
opened, then closed all the way, and the correct flames
cannot be attained, turn off the gas and contact the
dealer.
Less Air
More Air
