24
Initial Installation
QUALIFIED INSTALLERS ONLY
e
xhaust
R
estRictoR
:
1
2
3
4
Vent Length
Restrictor
Setting
10’-20’
(3.05-6.1m)
1
20’-30’
(6.1-9.1m)
2
30’-40’
(9.1-12.2m)
3
This fireplace has an internal exhaust restrictor that can adjusted
externally while the fireplace is in operation. Depending on the length
of venting required for installation this may need to be adjusted.
The restrictor is accessed from the front of the fireplace through the
discharge opening as shown above. Using a 3/8” socket on a 10”
long extension, rotate the restrictor COUNTER-CLOCKWISE until the
required setting is inline with the finger catch. Refer to Table 5 for the
required restrictor setting.
Note: The restrictor is set to setting #1 from the factory.
Figure 27: Exhaust Restrictor
Table 6: Restrictor Settings
FINGER CATCH
instaLLation instRuctions:
1. Plan your installation and clearances
to combustibles. The
EX32 may be
installed and vented into any solid
fuel fireplace that has been installed
in accordance with the National,
Provincial/State and local building
codes and has been constructed of
non-combustible materials. Also refer
C
learanCes
to
C
ombustIbles
section.
2.
Remove door. See
m
aIntenanCe
anD
s
erVICe
- g
lass
D
oor
r
emoVal
.
2ft (0.6m)
Minimum
3ft (0.9m)
Minimum
Within
10ft (3m)
Roof ridge or
any other portion
of a building
Figure 28: Roof Clearances.
i
nstaLLing
the
ex32:
• Remove the crate and packaging from the appliance and check to make sure there is no damage.
Carefully check the glass door. Do not use the unit if it is damaged. In the event damage is found,
please report it to your dealer as soon as possible.
• Carefully clean the fireplace and flue before installing the stove. Failure to do so may result in fumes
or soot being blown into the room and may cause a fire leading to death or serious injury.
3. Remove packaged log set and all wrapping material from the stove. Remove wrapping material from
the log set and check for any damage. If damage is observed, do not use unit and contact your local
dealer.
