7
November 2011
Insert Flue Kit (52)
Each 52 Insert Flue Kit contains:-
y
ti
t
n
a
u
Q
n
o
i
t
p
i
r
c
s
e
D
o
N
t
r
a
P
2
Stainless steel inner liner
ø75mm x 900mm long
5
8
Rain cap 75mm
1
12
T-adaptor/cleanout – ø75mm
1
16
Clamp – flexible flue to
stainless flue pipe
1
19
Flexible flue pipe – stainless
steel ø75mm x 1m
1
21
Bracket 75mm securing
flue pipe to wall
1
839
Casing cover – standard
ø75mm - ø300mm
1
34
Chimney cover – may be required
as an optional extra
This flue kit may be used in replacement applications
in masonry chimneys. The overall height of the flue is
4.5m. Kit is supplied in two cartons.
Note:
The Davin 52 Insert Flue Kit
complies with AS/NZS 2918:2001 as per
Applied Research Test Report 05/1185,
dated 15 September 2005.
All fires must be installed by a qualified
installer as per the manufacturer’s
instructions and AS/NZS2918:2001.
Heat-resistant
floor protector
Seismic restraint chain. To be fitted one on each
side of the fire at the mid point. The chain should
have a breaking strength of at least 350kg or
minimum 3.5mm nominal diameter. Chains
should be anchored to the floor (not framing or
masonry), and should be as short as possible,
only allowing access to unbolt the chains from the
fire to allow the fire to be pulled forward for servicing.
Chimney cover
– optional extra
150mm
(minimum)
Insert Flue Kit
52
To order :
December 2006
Telephone 0800 765 431. Fax 64 3 341 8057 [email protected] www.switchenergy.co.nz
Drawing representative only - not to scale.
