Enviro DV42DX, Руководство пользователя

Страница: 31 / 39

31
Figure 43: Final Log Set Arrangement with Embers.
Secondary Installation
Figure 44: DV42DX Burning.
Figure 42: Fourth Stage Log Set Installation.
Figure 42: The left log rests on the left pin
and ledge of the back log and the back of the
andiron.
Figure 43: The last log, center log , rests on
the end of the grate and on the ledge cut-out
in the center of the back log.
Once the logs are in place the
embers can
be installed. Bags of ceramic fiber embers
and rock wool are provided. The ceramic
fiber comes in chunks that are about 2 inches
(5cm) long. Place them irregularly around the
burner. When there is a sparse but even layer
of embers, spread the rock wool in the same
manner. DO NOT pack the rock wool material
as this could create an unsafe condition. The
pieces should be lightly placed so they don’t
completely block any of the tiny ports. DO
NOT allow any of the embers to rest against
the pilot assembly.
Caution: Use only the type of ember material
supplied with this fireplace. Due to the
irregular size of the ember material, there
may be more than required. Use of other
foreign materials on the burners may create
dangerous conditions.
Figure 44: Refer to this figure when
adjusting the venturi and vent
restrictor. Make adjustments so that
the flame reaches the approximate
height shown
NOTE: While the glass is still removed,
it is recommended that the gas line
be purged by lighting the pilot.
When lighting the fireplace for the
first time since the log set and
embers have been installed/replaced,
watch for ignition at ALL the burner
ports. If a long delay is noticed, turn
the appliance off and wait for it to
cool down. Then remove the glass
and rearrange the ember material,
making sure none of the burner ports
are blocked.