Figure 17. Accent 20 complete log set-up with embers burning.
Figure 17: The Accent 20 burning with a good flame.
NOTE: While the glass is still removed, it is recommended that the gas line be purged by lighting the
pilot.
When lighting the fireplace for the first time since the log set and embers have been installed/replaced,
watch for ignition at ALL the burner ports. If a long delay is noticed, turn the appliance off and wait for it
to cool down. Then remove the glass and rearrange the ember material, making sure none of the burner
ports are blocked.
IMPORTANT NOTE RE FIRST FIRE UP:
When the unit is turned on for the first time, it should be
turned to high without the fan for the first 4 hours. This will cure the paint, logs, gasket material and
the other products used in the manufacturing process. It is advisable to open a window or door, as the
unit will start to smoke and can irritate some people. After the unit has gone through the first burn, turn
the unit off including the pilot, let the unit cool then remove the glass door and clean it with a good gas
fireplace glass cleaner, available at your local ENVIRO dealer
Maintenance:
Once a year, the logs should be removed and checked for deterioration or large amounts
of soot. A small amount on the bottom side of the logs is normal. Remove and replace the logs in the
same manner described above. If new/more embers and rock wool is required, contact your nearest
ENVIRO dealer.
Never operate the fireplace with the glass door removed.
R
EMOVING
A
ND
I
NSTALLING
T
HE
B
RICK
P
ANELS
:
Secondary Installation
The Accent 20 comes with the brick panel set pre-installed but for
some maintenance and installation procedures the panels must be
removed.
1. Use a 1⁄4” socket or a flat head screwdriver to remove the brick
panel brackets on either side of the top of the firebox (refer to
Figure 18).
Figure 18: Brick panel bracket.
18
