Installation
Please read and understand these instructions before installing pedestal or ash pan and leg option.
Failure to follow these instructions carefully could cause personal injury or property damage.All screws
are pre installed on the base of the unit.
p
edestal
i
nstallation
:
l
egs
a
nd
a
sH
p
an
i
nstallation
:
• Remove the bricks from the unit before starting.
• Loosen the two (2) carriage bolts that secure the
unit to the pallet. Slide the pallet towards the front
to release carriage bolts from the key holed slots in
the unit. Place the unit on the pallet on its back.
• Slide the pedestal assembly over the bolts located
on the base of the unit using the key holed slots
provided.
• Tighten all four (4) bolts ensuring the pedestal is
properly aligned to the edges of the unit.
• Ensure that the gasket material is properly sealed
before continuing.
• Stand the unit on the pedestal and set the unit in
the location ready for installation.
• If fresh air supply is being supplied from the bottom
of the unit please install the cover plate supplied to
the rear of the pedestal covering the 4 inch (10 cm)
hole.
• Remove the bricks from the unit before starting.
• Loosen the two (2) carriage bolts that secure the
unit to the pallet. Slide the pallet towards the front
to release carriage bolts from the key holed slots in
the unit. Place the unit on the pallet on its back.
•
Slide the ash pan assembly over the bolts using
the key holed slots provided and tighten all four
(4) bolts.
•
Ensure that the gasket material is properly sealed
before cleaning.
•
Carefully remove the cast iron legs from the
packaging and secure each leg with two (2) bolts
provided.
•
Secure all four (4) legs, push the leg towards the
center of the stove and align the legs with the
outer edges of the firebox.
•
Stand the unit on the legs and set the unit in the
location ready for installation
10