Enviro Gas EG-40 FPI BV Скачать руководство пользователя страница 2

SAFETY PRECAUTIONS

  

FOR SAFE INSTALLATION AND OPERATION OF YOUR "ENVIROGAS" ROOM HEATER, PLEASE, CAREFULLY 
READ THE FOLLOWING INFORMATION: 
 

• 

All "ENVIROGAS" gas-fired appliances must be 

installed in accordance with these instructions.  Carefully 
read all the instructions in this manual first.  Consult the 
building authority having jurisdiction to determine the need 
for a permit prior to commencing the installation. 
 

• 

NOTE 

Failure to follow these instructions could cause 

a malfunction of the fireplace that could result in death, 
serious bodily injury, and/or property damage.   

• 

Failure to follow these instructions may also void your 

fire insurance and/or warranty. 
 
 

GENERAL 

• 

Installation and repair should be done by a 

qualified service person.  The appliance should 
be inspected before use and at least annually by 
a qualified service person.  More frequent 
cleaning may be required due to excessive lint 
from carpeting, bedding material, etc.  It is 
imperative that control compartment, burners 
and circulating air passageways of the appliance 
be kept clean. 
 

• 

Due to high temperatures the appliance 

should be located out of high traffic areas and 
away from furniture and draperies. 
Children and adults should be alerted to hazards 
of high surface temperatures and should stay 
away to avoid burns or clothing ignition. 
 

• 

Young children should be carefully 

supervised when they are in the same room as 
the appliance.   
 

• 

Clothing or other flammable material should 

not be placed on or near the appliance.   

 
FOR YOUR SAFETY

 

• 

A qualified installer, service agency or the gas supplier 

must perform installation and service. 
 

• 

This installation must conform with local codes or, in 

the absence of local codes with the current CAN/CGA -B-
149  

installation code in Canada or the National Fuel Gas Code 
ANSI Z223.1.2 in the USA. 
 

• 

To prevent injury, do not allow anyone who is 
unfamiliar with the operation to use the stove.   

 

• 

Always keep the area around these appliances clear 

of combustible material, gasoline or other flammable 
vapors and liquids.   
 

• 

These appliances should not be used as a drying rack 

for clothing or for hanging Christmas stockings or 
decorations. 
 

• 

Due to the paint curing on the stove a faint odor and 

slight smoking will likely be noticed when the stove is first 
used.  Open a window until the slight smoking stops. 
Always connect this gas stove to a chimney and vent to 
the outside of the building envelope.  Never vent to 
another room or inside a building. Make sure you use the 
vent pipe that is specified. Make sure that the vent is 
properly sized and is of adequate height to provide the 
proper draft.  Inspect the venting system annually for 
blockage and any signs of deterioration. 

 

• 

 Do not operate with cracked or broken 

glass.  Under no circumstances should this 
appliance be modified.  Parts that have to be 
removed for servicing must be replaced prior 
to operating this appliance.  Only parts 
supplied by ENVIROGAS should be used in 
this appliance and replacements should only 
be performed by a licensed or qualified 
service person.  

 

• 

Never use solid fuels such as wood, paper, cardboard, 

coal, or any other flammable liquids etc., in this appliance. 
 

• 

Do not use this heater if any part has been under 

water.  Immediately call a qualified service technician to 
inspect the heater and to replace any part of the control 
system and any gas control that has been under water. 
 

• 

Do not abuse glass by striking or slamming door shut. 

 

 

 

 

2

Содержание EG-40 FPI BV


















Отзывы: