Enttec PIXEL PORT, Руководство пользователя

Страница: 9 / 18

User Manual
Pixel Port
For the latest version visit:
www.enttec.com
21 September 2017 ID: 3617472 P a g e | 7
Settings
The Settings tab allows an end user to do the
following:
•
Change a device name for identification
•
Enable/disable DHCP
•
Set a specific Static IP address
•
Set a specific Static NetMask
•
Set the input DMX Protocol
•
Set the output LED Protocol
•
Chose a personality for mode of operation
•
Set the number of universes output
•
Map an Art-Net universe to the output
•
Configure how colours are mapped to pixel
•
Set number of pixels that are controlled
during effects mode
•
Pixel grouping settings
•
Reset to factory defaults
•
Reboot device
Network Stats
The Network tab shows statics such as:
•
Poll packets received
•
Last IP poll packets were received from
•
Data packets received
•
Data packets send
Update Firmware
In addition to providing a method to update the
device firmware this tab shows the following:
•
The boot version on the device
•
The firmware version on the device
•
The device mac address
•
The device serial number
•
DHCP status
•
Device IP address
Network Settings Explained
Node Name
Node name is used to identify the unit on the network.
Any meaningful name can be used.
DHCP
DHCP is enabled by default. When enabled, the router
on the network, which the device is connected to, is
expected to automatically provide the IP address to
the unit. If no DHCP router/server is present on the
network, the manual IP address will be used.
If for some reason, the unit does not get an IP address
via DHCP, please restart the unit with the Ethernet
cable connected. It will listen for DHCP on start-up and
wait for a few seconds, before giving up.
IP Address and Netmask are only used if DHCP is
disabled or is unavailable on the network. Pixel Port