User Manual
Pixel Port
For the latest version visit:
www.enttec.com
21 September 2017
ID: 3617472
P a g e
|
8
web-page will warn, if non-standard IP address or
netmask is used.
If the device is assigned an IP Address that can't be
connected to later, please perform the reset
procedure (as described under
Tips and Tricks
). The
reset will re-enable DHCP on Pixel Port.
DMX Protocol
This setting allows the input DMX over Ethernet
protocol to be picked. Available options:
•
Art-Net
•
sACN
•
ESP
Notes:
For Art-Net, Net and Subnet can be specified and should
comply with Art-Net 3 protocol.
Pixel Mapping Options Explained
Universe/Output
The
Pixel Port in direct mode allows conversion of
up to two universes of DMX over Ethernet to pixel
data.
Available options are:
Option
No. of universes mapped
None
No output
1
One universe drives first 170 pixels in RGB
mode or first 128 in RGBW
2
Two universes drive first 340 pixels in RGB
mode or first 256 in RGBW
First/Second Universe
Allows selections of the universe that the output will
be mapped to.
The first universe drives the first 170 Pixels in RGB
modes, or the first 128 Pixels in RGBW modes.
The second universe drives pixels 171-340 in RGB
modes, or the pixels 129-256 in RGBW modes.
The second universe setting is disabled if
Universe/Output is set to one as shown in image.
For Art-net universe, please change Net/Subnet to
increase combined universe beyond 15. (Combined
universe is shown under the selection).
Pixel Order
There are 30 different pixel order options. Ordering
controls how the DMX slots are mapped to the LED
Содержание PIXEL PORT
Страница 1: ...PIXEL PORT ETHERNET PIXEL DRIVER...
