46
Resetting to Factory Settings
1. To reset the device to factory settings, press the SET button while "FACT RST" is displayed.
2. While "FACtorY rSET" is displayed, pin code must be entered when the SET button is pressed.
3. Enter your pin code with UP/DOW N buttons. Press the SET button.
4. If the pin is entered correctly,
“No”
will be displayed at the bottom of the screen.
5. Press the SET button and change the
“No”
option to
“
Yes
”
with UP/DOWN buttons.
6. When exiting from the menu with the BACK button, don
’
t forget to save the changes.
7. 3 seconds after you exit from the menu, device version will be displayed and device installation
process will start.
After completing the settings, voltage measurement screen will be displayed.
Displaying Software and Hardware Version
The device
’
s hardware and software version can be displayed under this menu:
1. Press the SET button while "Soft VER" is displayed under System menu.
2. Software version of the device will be displayed on the bottom of the screen.
3. When you press the UP button here, hardware version of the device will be displayed under
"HArd VerSIon".
Displaying Serial Number of the Device
1. Press the SET button while "Serial N" is displayed under System menu.
2. 8 digit serial number of the device will be displayed under "SErIAL no".
