Installing the Module into the 6C105 Chassis
Installation
3-11
3.4
INSTALLING THE MODULE INTO THE 6C105 CHASSIS
Certain restrictions may apply when installing the module into the 6C105 chassis. Refer to the
Release Notes for any updated information concerning installing the module into the 6C105
chassis. Otherwise, the installation procedure from
Section 3.3
can be followed, with the exception
of the fact that the 6C105 chassis has only 5 slots as opposed to the 7 slots in the Matrix E7. The
module can be installed in any of the slots that are available. To install a module, refer to
Figure 3-7
and proceed as in
Section 3.3
.
CAUTION:
Failure to observe static safety precautions could cause damage to the
module. Follow static safety handling rules and wear the antistatic wrist strap provided
with the 6C105 chassis.
Do not cut the non-conductive bag to remove the module. Sharp objects contacting the
board or components can cause damage.
NOTE:
The DCM (Distributed Chassis Management) and SecureFast Switching
functionality of the SmartSwitch 6000 is supported when the modules are installed in a
6C105 SmartSwitch 6000 chassis. Refer to the module release notes for specific
information on supported functionality.