Enterasys Matrix 7G4202-30, Руководство по установке оборудования

Страница: 47 / 110

Installing Module into Matrix E7 or N7 Chassis
Installation 3-11
3.5 INSTALLING MODULE INTO MATRIX E7 OR N7 CHASSIS
To install any module into the Matrix E7 chassis, refer to Section 3.4 to familiarize yourself with
the FTM1 and FTM2 backplane connections and the module hardware installation rules. Then
proceed to
Section 3.5.1 to start the installation process.
To install a DFE module into a Matrix N7 chassis, proceed directly to Section 3.5.1 to start the
installation process.
3.5.1 Preparation
1. Remove the blank panel covering the slot in which the module will be installed. All other slots
must remain covered to ensure proper airflow for cooling. (Save the blank plate in the event you
need to remove the module.)
2. Remove the module from the shipping box. (Save the box and packing materials in the event the
module needs to be reshipped.)
3. Locate the antistatic wrist strap shipped with the chassis. Attach the antistatic wrist strap to your
wrist and plug the cable from the antistatic wrist strap into the ESD grounding receptacle at the
upper right corner of the chassis.
4. Remove the module from the plastic bag. (Save the bag in the event the module must be
reshipped.) Observe all precautions to prevent damage from Electrostatic Discharge (ESD).
5. Examine the module for damage. If any damage exists, DO NOT install the module.
Immediately contact Enterasys Networks. Refer to “
Getting Help ” on page xxii.
Caution: Failure to observe static safety precautions could cause damage to the
module. Follow static safety handling rules and wear the antistatic wrist strap.
Do not cut the non-conductive bag to remove the module. Sharp objects contacting the
board or components can cause damage.
Precaución: Si no toma las medidas de seguridad necesarias para evitar descargas de
electricidad estática, es posible que el módulo se dañe. Siga los consejos de seguridad
para la manipulación del producto y no olvide utilizar la pulsera antiestática.
No corte la bolsa antiestática para sacar el módulo. Tenga en cuenta que si algún objeto
cortante entra en contacto con la placa o con los componentes, éstos podrían dañarse.