Enplus EVO UPS 10000VA, Руководство пользователя

Страница: 18 / 40

18
7.1 Starting and shutting down the UPS
Starting the UPS
Ensure that installation was correct and successful and that the input power cable is
connected to a well-grounded outlet.
The UPS can be started by pushing the “ON/OFF” button on the front panel.
The UPS should now start its inspection of: internal functions, main synchronization
and inverter startup. Then power should start to be supplied via the terminal block.
During this inspection, the LCD will display “Ready on”. The LED shall light up
when output power has commenced and the LCD will display “Line mode”.
Switch on the loads.
Shutting down the UPS
Shut down and turn off the loads.
Push the “ON/OFF” button on the front panel for two seconds. The alarm will sound
and the UPS will shut down.
The LCD will display UPS OFF for a few seconds.
In emergency situations, the EPO located on the back of the unit should be used.
7.2 Button operation
Please note the five operating buttons on the front panel:
1. “ON/OFF” button:
(a) Push “ON/OFF” button (at least 1 seconds) to turn on the UPS.
(b) When UPS is working, push the “ON/OFF” button(at least 2 seconds) to turn
off the UPS.
2. “STATUS” button:
Use this button to check content of UPS and the method is listed below:
(a) Push the “STATUS” button (at least 2 seconds) to check content of UPS.
Each content can be displayed by pressing at once, and it has fifteen kinds of
function to be checked.
(b) If no pressing within 10 seconds, it will return to original status.