USER MANUAL
PTM 535 / PTM 535U / PTM 535J
–
ENOCEAN TRANSMITTER MODULE
© 2019 EnOcean | www.enocean.com
F-710-017, V1.0
PTM 535 / 535J User Manual | v1.5 | September 2020 | Page 29/36
6.2.2
FCC regulatory statement
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions:
1.
This device may not cause harmful interference, and
2.
This device must accept any interference received, including interference that may
cause undesired operation.
To comply with FCC/IC RF exposure limits for general population / uncontrolled exposure,
the antenna(s) used for this transmitter must be installed to provide a separation distance
of at least 20 cm from all persons and must not be co-located or operating in conjunction
with any other antenna or transmitter
Warning
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Interference
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasona-
ble protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a par-
ticular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one of the following measures:
◼
Reorient or relocate the receiving antenna.
◼
Increase the separation between the equipment and receiver.
◼
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
◼
Consult the dealer or an experienced radio/TV technician for help.
