USER MANUAL
ESRPB / EDRPB - EASYFIT BLUETOOTH® SINGLE / DOUBLE ROCKER PAD
© 2018 EnOcean | www.enocean.com
F-710-017, V1.0
ESRPB / EDRPB User Manual | v1.3 | Jan 2018 | Page 26/68
5.3.3
Exit from commissioning mode
Pressing any key except the button used for entry into commissioning mode (
Button_X
) will
cause ExRPB to stop transmitting commissioning telegrams and return to normal data tele-
gram transmission.
5.4
Factory Reset
ExRPB can be reset to its default settings by means of a factory reset.
This ensures that ExRPB can be reset to a known configuration in case the PIN for the NFC
access has been lost or NFC access is not possible for other reasons
In order to execute such factory reset, the rocker(s) and the switch housing have to be
removed from ExRPB so that all four ExRPB module contacts and the energy bar are acces-
sible.
After that, all four button contacts (A0, A1, B0 and B1) have to be pressed at the same
time while the energy bow of the ExRPB module is pressed down.
The energy bow must then be held at the down position for at least 10 seconds before be-
ing released. The button contacts A0, A1, B0 and B1 can be released at any time after
pressing the energy bow down, i.e. it is no requirement to hold them as well for at least 10
seconds.
Upon detecting this input, ExRPB will restore the default settings of the following items:
Static Source Address
Security Key
and
Security Key Write
register
Both registers will be restored to the value of the factory-programmed security key
Manufacturer ID
The manufacturer ID will be reset to
0x03DA
(EnOcean GmbH)
NFC PIN Code
The NFC PIN Code will be reset to
0x0000E215
After such factory reset, Source Address and Security Key will again match the content of
the DMC code on the unit label as described in chapter 7.
In addition, ExRPB will reset the following registers:
Configuration
register (to
0x00
)
Custom Channels
Register (to
0x00
)
