Repeater-EnO868SELV
EnOcean Repeater 868 MHz
Repeater-EnO868USB
Read the operating instructions carefully before commissioning.
Installation and operating instructions
Rev.: February 2016
Repeater-EnO868_104126_OperationManual_E_FEB2016.doc/pdf
Page 1 of 7
BootUp GmbH
|
Sonnenbergstrasse 23
|
CH-5236 Remigen
|
Switzerland
|
Phone +41 56 284 09 21
|
Fax +41 56 284 09 22
2016
|
Omi technical changes excepted
|
www.BootUp.ch
|
www.myHomeControl.ch
|
Installation and operating instructions
Model / Typ
Description
Part No.
Repeater-EnO868USB
EnOcean Repeater (radio amplifier) 868 MHz , Power supply via USB
port, with USB power supply unit (EC), black
104126
Universal repeater (radio amplifier) for all EnOcean products
•
EnOcean TCM 300 (Dolphin Inside) future-proof and backward-compatible
•
Optimized RF antenna design combined with the surface-mounted location,
for exceptionally good radio range.
•
Attractive designer plastic housing for surface mounting (Wall or ceiling)
made of ABS flame retardant.
•
Power supply via USB interface, with USB type A plug and approx.
1.2 m cable or with SELV with 6V DC, via cable 1.2 / 2.2m with open ends.
•
Repeater function selectable by hardware switch (no repeater, only post-master or level 1 or level 1 + 2).
•
Future-proof, because of "Dolphin Inside". Supported services: The old and new EEPs, Post-Master for up
to 10 Ids, Smart-ACK and Remote Management (locate).
Application
Universal repeater (radio amplifier) for EnOcean radio technology. The radio transmission takes place on the
European harmonized frequency of 868.3 MHz. With this device, the range between EnOcean transmitters and
receivers can be increased. The radio signal can be cascaded to the receiver via a maximum of two repeaters.
A configuration or teach-in is not required. Also as a replacement for radio range problems in existing
installations. This device is identical and replaces the predecessor RepeaterEnO868USB Article-No. 104107
and RepeaterEnO868SELV Article-No. 104106.
Function
The repeater is used for signal amplification of the radio telegrams between EnOcean sensors and receivers.
This function is used when the sensor placement is outside of the receiving range of the receiver or there are
range problems between transmitter and receiver in an existing installation.
In position
Rep. ON
is the Repeater function active. All received EnOcean telegrams will be re-sent
automatically. The sent telegrams are marked as repeater signals. This tag distinguishes once or twice
forwarded signals.
In operating mode
Level 1
, only original telegrams, which are telegrams originate directly from a transmitter, are
processed and amplified again.
In operating mode
Level 1+2
, only original telegrams and, in addition, telegrams that have already been
amplified once are processed and amplified again.
If the repeater is switched off
Rep. OFF
, then only the post master is active.
Technical specifications
Supply voltage: 4.75..8V DC or via USB Power consumption: typically 70 mA @ 5V DC
Antenna: internally
Transmitter: EnOcean TCM 300, Step Code: DB
Transmission power: <10mW
Housing: ABS flame retardant, white cover, black bottom
Transmission frequency: 868.3 MHz
Humidity: 0 ... 75% rh, non-condensing
Ambient temperature: 0...45°C
Storage temperature: -25...75°C
Protection class: IP20 IEC/EN 60529
Dimensions: diameter 93 mm height 29 mm
CE Marking
Weights: 125g
