Page 2
Page 3
Page 4
The Ruggedized sensor is shipped with the cable
attached to the sensor. The sensor can be mounted to
the fixture using a conduit body and chase nipple or
locknut.
Step 1
: De-energize the luminaire.
Step 1
: Remove the cover plate of the
½
inch LB
conduit body by removing the two screws.
Step 2
: Thread the
Ruggedized sensor onto
the LB conduit body.
Step 3
: Replace the cover
and two screws on the LB
conduit body.
Chase Nipple
Enlighted
Control Unit
Step 1
: Knock out a
½
inch hole on the bottom of the
light fixture.
Step 2
: Glide the sensor cable through the knockout of
the fixture.
Step 4
: Knock out a
½
inch hole on the end of the light
fixture.
Step 6
: Thread the chase nipple to securely connect
the LB conduit to the fixture.
Caution
Installation and maintenance must be performed by a qualified
electrician in accordance with local, state, and national
electrical codes (NEC) and requirements.
Installation
Mounting using the Conduit Body and Chase
Nipple
Mounting using the Locknut
Step 3
: Thread the locknut tightly to secure the sensor to
the fixture.
Step 2
: Energize the luminaire and confirm that the
green LED is on solid. Refer to the
LED Descriptions
on
page 5.
Step 1
: Use an RJ45 coupler with an Enlighted Sensor
cable to connect the RJ45 end of the sensor cable to
the connector of the Control Unit (CU).
For wiring connections from the Control Unit to the
sensor, refer to the
Control Unit Installation Guide
.
Connecting the Sensor Cable to the Control
Unit
Step 5
: Mount the Ruggedized Sensor LB Conduit to
the fixture by guiding the sensor cable through the
knock out and chase nipple into the fixture.