Engl Ironball SE E606SE, Руководство оператора

Страница: 9 / 16

FX Loop
In the signal path, the FX Loop is located post preamp and before the power amp Master controls.
FX Loop Send
Connect the FX Loop Send (output) to a signal processor´s input or an effect pedal´s input/return
jack using the shortest possible shielded cord (conventional 6,3mm / ¼“ TS).
FX Loop Return
Connect the FX Loop Return (input) to a signal processor´s output or an effect pedal´s
output/send jack using the shortest possible shielded cord (conventional 6,3mm / ¼“ TS).
IR Selector
This rotary switch allows you to select between eight different IRs. The first three are built-in ENGL
IRs:
1 - ENGL E212VHB (V30) Cabinet
2 - ENGL E412VSB (V30) Cabinet
3 - ENGL E412XXL (V30) Cabinet
The selected IR can also be stored to the a respective MIDI Preset. When selecting an unused or
let´s say free slot, the IR section is bypassed automatically.
Select and store an IR to a respecitve channel
Any IR can be simply assigned to the Clean channel and the Lead channel. This works without having
a MIDI footswitch and with or without having a TRS footswitch (Z4) connected.
1. Select a channel (Clean or Lead).
2. Select the IR you want to save to the channel.
Now the setting is saved temporarily (for this session) and will discarded by switching the amp off.
You can assign one specific IR to the Clean and another one to the Lead channel. When you change
the selection while the respective Channel is active, the new setting will be saved temporarily. To
save the setting permanently you need to go on with step 3.
3. Press and hold the Store push button for about 2 seconds until the Store LED begins to flash 3
times short to indicate that the selected IR is saved to the channel.
Please note, that MIDI PC #1 will be overwritten by this process.
Via MIDI you can select and save a specific IR to every preset. You just have to select the IR you
want to save to the preset and follow the standard Store procedure. Press and hold the Store push
button for about 2 seconds until the Store LED begins to flash 3 times short to indicate that the
selected IR is saved to the channel.