Engl Ironball SE E606SE, Руководство оператора

Страница: 6 / 16

Power Range Selector
Use this switch to activate the Power Soak and select the desired power level.
Full Power (approx. 20 Watts)
Mid Power (approx. 5 Watts)
Low Power (approx. 1 Watt)
Speaker Off (zero Watts)
When activated, the Power Soak´s resistors convert some or all of the power amp´s output into
heat. So, make sure air can circulate freely around the back of the amp!
Main Supply Connector (AC Power Inlet, IEC – C14 connector)
Plug the mains cord in here.
CAUTION! Make sure you use an intact mains line cord with a grounded plug! Before you power the
amp up, ensure the voltage value (e.g. printed on the Type Label or alongside the mains port) is the
same as the current of the local power supply or wall outlet. Please also heed the guidelines set
forth in the separately included pamphlet, Instructions for the Prevention of Fire, Electrical Shock
and Injury.
Mains Fuse Box
The rear chamber contains the mains fuse and the front chamber a spare fuse.
NOTE:
Ensure replacement fuses bear identical ratings (refer to the technical data)!
CAUTION!
Always make sure replacement fuses are of the same type and have the same ratings as
the original fuse! To this end, please refer to the fuse ratings shown on the type panel.
Footswitch:
Clean/Lead and Gain Boost (conventional 6.3mm / ¼“ TRS). Use this jack to connect a conventional
footswitch with two switching functions, i.e. the ENGL Z4 (2 x off/on – Single Pole Single Throw or
SPST for short).
Tip:
switching between the Clean and the Lead channel.
Ring:
switching Gain Boost on and off.
Phantom Power - ENGL Midi Footcontroller
This selector activates a MIDI In port phantom power supply for powering an ENGL MIDI
footcontroller when connected to the amp. When the switch is pushed in, power is routed to the
MIDI In port´s pin 1 and pin 2. If you want to use a 3
rd party MIDI footcontroller, be sure that the
switch is unpressed to avoid damaging the amp or the footcontroller.