XF
Rev: 4, 2010-02-01
Page 7
Image A
2.2.5.
Coding of wireless remote control
Procedure for serial no. above 8600
Important!
If your wireless control has serial no. lower than 8600, use the
procedure enclosed your remote.
1. How to put the wireless control unit in code mode:
Select the pair of switches on the remote control to be coded.
Press down both switches simultaneously for approximately 12 seconds.
When you hear a short sound signal and the green power light starts to
flash,
the remote control
is prepared for coding and will stay in coding
mode for 5 minutes or until the coding has been finished.
(Image A)
Image B
Image C
Image D
2. How to put the receiver unit in code mode:
Alt. 1. Touch panel installed.
Press and keep both switches on the touch panel down while
simultaneously switching on the power to the receiver unit.
(Image B and C)
The receiver will now understand that coding is requested and
automatically connect to your wireless control and the wireless remote
control will immediately be ready for use.
This will be confirmed by a short sound signal and the green power light
will turn from flashing to permanent.
Check that the wireless control is functioning.
Alt. 2. Joystick installed.
Turn the thruster main switch
off
.
Disconnect the cables to the joystick connected to 1, 2 and 3 on the
green plug on the remote control unit (RCU).
Prepare two short wires (5 cm). Remove the insulation in both ends and
connect these between 1 and 2 as well as between 2 and 3 on the green
plug. (Image D).
Turn the power
on
.
The receiver will now understand that coding is requested and
automatically connect to your wireless control and will immediately be
ready for use.
This will be confirmed by a short sound signal and the green power light
will turn from flashing to permanent.
Turn the thruster main switch
off
.
Disconnect the short wires and connect the joystick cables.
Turn the power on and check that the wireless control is functioning.