ENFORCER HDMI Extender over IP
8
SECO-LARM U.S.A., Inc.
NOTICE: The SECO-LARM policy is one of continual development and improvement. For that reason, SECO-LARM
reserves the right to change specifications without notice. SECO-LARM is not responsible for misprints. Trademarks are
the property of SECO-LARM U.S.A., Inc. or their respective owners.
Copyright © 2016 SECO-LARM U.S.A., Inc. All rights reserved. This material may not be reproduced or copied, in whole or
in part, without the written permission of SECO-LARM.
WARRANTY:
This SECO-LARM product is warranted against defects in material and workmanship while used in normal
service for the one (1) year from the date of sale to the original customer. SECO-LARM’s obligation is limited to the repair
or replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM. This Warranty is void if
damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect, repair or alteration,
improper or abnormal usage, or faulty installation, or if for any other reason SECO-LARM determines that such equipment
is not operating properly as a result of causes other than defects in material and workmanship. The sole obligation of
SECO-LARM and the purchaser’s exclusive remedy shall be limited to the replacement or repair only, at SECO-LARM’s
option. In no event shall SECO-LARM be liable for any special, collateral, incidental, or consequential personal or property
damage of any kind to the purchaser or anyone else.
SECO-LARM
®
U.S.A., Inc.
16842 Millikan Avenue, Irvine, CA 92606 Website: www.seco-larm.com
PICSN6
Tel: (949) 261-2999 | (800) 662-0800
Email: [email protected]
MI_MVE-AHMPM-01NQ_160520.docx
HDMI, the HDMI Logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing
LLC in the United States and other countries.
MVE-AH010Q
HDMI Extender over Dual
Cat5e/6
MVE-AH030Q
HDMI Extender over Single
Cat5e/6
High-Speed
HDMI Cables
MVS-AH31-01NQ
MVS-AH51-01NQ
4K HDMI Switchers
MVD-AH12-01Q
MVD-AH14-01Q
MVD-AH18-01Q
4K HDMI Splitters
MVE-AH030AQ
Basic HDMI Extender over
Single Cat5e/6
4.
Select "System Settings" and change the last segment of the IP address shown to a unique
number between 1 and 254.
5.
Change the final digits of the MAC address from the default (TX: 00:0b:78:00:60:01,
RX: 00:0b:78:00:60:02) to a unique hexadecimal number between 01 and FF.
6.
Click "Apply" to enable the changes.
7.
Repeat for each additional TX/RX and then install as described in "Installation" on pg. 4 and
consult the diagrams on pgs. 5-6 as necessary.
Also Available from SECO-LARM:
Changing the IP and MAC Address (cont.):
