ENFORCER HDMI Extender over IP
4
SECO-LARM U.S.A., Inc.
Sample Application — One-to-One:
Installation:
Cable Legend:
HDMI
Power
IR
Cat5e/6
NOTE: For One-to-Many and Many-to-Many installations, each receiver/transmitter's IP and MAC
addresses must be unique. See "Changing the IP and MAC Address" on pgs. 7-8 before
installation.
1.
Determine the location where the HDMI Extender over IP units will be installed as well as how
much Cat5e/6 cable will be necessary.
2.
Connect the transmitter to the HDMI output of the source device.
3.
Connect the transmitter and receiver:
a.
If connecting One-to-One, connect one end of the Cat5e/6 cable to the transmitter and
the other end directly to the receiver.
b.
If installing with a switch or router, connect one end of the Cat5e/6 cable to the transmitter
and the other end to a switch or router. Then, with a second Cat5e/6 cable connect the
receiver to the other end of the switch or router.
4.
Connect the receiver to the HDMI input of the display or other device.
5.
Connect one 5VDC adapter to the transmitter and the other to the receiver.
6.
Determine which device, if any, will be controlled by remote control.
a.
Install the IR transmitter to the IR port near the device to be controlled, pointing the IR
transmitter at its IR sensor.
b.
Install the IR receiver to the IR port of the other transmitter/receiver, pointing the IR
receiver in a direct line of sight to where the remote control will be.
c.
Point the remote control at the IR receiver when in use.
7.
Switch on the HDMI source and display to verify that the system is functioning properly. It
may take up to a minute to sync up the video stream.
Power
Adapter
HDMI Display
Transmitter
IR RX
Remote
Receiver
For maximum cable length,
see "Specifications"
IR TX
HDMI
Source
Power
Adapter
