ENFORCER HDMI Extender over IP
SECO-LARM U.S.A., Inc.
7
5.
By default VLAN1 will be configured and all ports on the switch will be assigned to it.
a.
Example default VLAN configuration:
VLAN1
Interface
P1
P2
P3
P4
P5
P6
P7
P8
Member
x
x
x
x
x
x
x
x
Tagged
Untagged
x
x
x
x
x
x
x
x
PVID
x
x
x
x
x
x
x
x
b.
Make note of which ports the transmitters and receivers will be connected to.
c.
Update the ports that will be connected to Transmitter 1 and its associated receivers.
d.
For this example, the first 4 ports (P1-P4) will be connected to Transmitter 1 and its
associated receivers by setting the "Member" values for P1-P4.
VLAN1
Interface
P1
P2
P3
P4
P5
P6
P7
P8
Member
x
x
x
x
Tagged
Untagged
x
x
x
x
x
x
x
x
PVID
e.
Click "Apply" or "Save" to enable the changes.
6.
Create a second VLAN for Transmitter 2 and name it VLAN2.
a.
Set the last 4 ports to be on VLAN2 by setting the "Member" values for P5-P8.
VLAN2
Interface
P1
P2
P3
P4
P5
P6
P7
P8
Member
x
x
x
x
Tagged
Untagged
x
x
x
x
x
x
x
x
PVID
b.
Click "Apply" or "Save" to enable the changes.
c.
Connect Transmitter 2 and its associated receivers to the last 4 ports (P5-P8).
d.
Confirm the source from Transmitter 1 is displaying on the receivers connected to P1-P4
and the source from Transmitter 2 is displaying on the receivers connected to P5-P8.
e.
If not, recheck the settings on VLAN1 and VLAN2 to make sure they are set correctly and
that the configuration has been saved.
Changing the IP and MAC Address:
1.
When there is more than one pair of transmitters/receivers connected to a switch/router, the IP
address and MAC addresses must be changed for the additional units.
2.
Connect a powered transmitter/receiver (TX/RX) to a computer using an Ethernet cable (Note
the computer may not have the same IP address as the transmitter/receiver). The power LED
on the TX/RX should be red and the status LED should be green.
3.
Open your web browser to the default link (TX: 192.168.168.55, RX: 192.168.168.56).
VLAN Setup (cont.):
