ENFORCER Dashboard Camera
SECO-LARM U.S.A., Inc.
5
Turning the Camera On:
1.
If the camera is connected to power, whenever the ignition is turned on, the camera will
automatically turn ON and begin recording.
2.
If the camera is not connected to power, press the power button on the top of the camera.
Once the camera is on, press the record button to begin recording.
Note:
If the car’s cigarette lighter/power port continues to power the camera even when the
ignition is off, use the power button to turn the camera ON and OFF to avoid battery drain.
1.
In order to access the Dashboard Camera’s menu, make sure the camera is not recording.
Check to see if the red “recording” dot is shown on the screen. If it is, press the record button
once to stop recording.
2.
Press the menu button in order to access the menu.
3.
Press the up and down buttons to cycle through the menu options.
4.
To select an option, press the record button.
5.
To exit the menu, press the menu button.
Look at the top of the screen. If the camera is in video mode, the video
icon will be at the top of the screen (see right).
Note:
By default, the camera should be in video mode.
If the camera is not in video mode, press the mode button until the
video icon is on the top of the screen.
In order to start recording a video, press the record button.
Video icon
How to Navigate the Dashboard Camera Menus:
Video Mode:
Up
Down
Menu /
Exit
Select/Record
Wide Dynamic Range
Power/Battery Indicator
Auto White Balance
Standby Speed Display
GPS Speed Warning
Driver Fatigue Warning
Time
Date
Motion Detection
Time Lapse
SD Card
Recording Length
Recording
Video Mode
Resolution
Sound
Exposure
Loop Recording
GPS Signal
