ENFORCER Dashboard Camera
4
SECO-LARM U.S.A., Inc.
IMPORTANT
Users and installers of this product are responsible for ensuring that the installation and configuration of
this product complies with all national, state, and local laws. SECO-LARM will not be held responsible for
the use of this product in violation of any current laws or codes.
1.
Before installing, insert a micro SD card (not
included) into the micro SD card slot (T-FLASH)
on the side of the camera. The camera will support
micro SD cards up to 32GB, class 6 or above.
2.
Slide the camera onto the bracket until it clicks.
3.
Determine how the camera will be powered. If
powering via cigarette lighter, make sure the mini
USB cable is in reach of the cigarette lighter. If
powering via optional fuse box connector, please
see
Powering the Camera: Optional Fuse Box
Connector
below.
4.
Determine where on the windshield the camera
will be mounted. Be sure that the camera will not
obstruct the driver’s view.
5.
Clean the area on the windshield where the camera will be mounted, making sure to remove
dust or any other particles.
6.
Lift the suction cup lever and place the suction cup on the windshield.
7.
Push down on the suction cup lever to lock the bracket into place.
8.
Connect the camera to power.
9.
Adjust the camera to ensure proper viewing angle.
Note:
To remove the camera from the bracket, squeeze the Mounting tab and slide the camera in
the opposite direction until it releases.
Slide camera
onto the bracket
Suction cup lever
Suction cup
Cigarette Lighter
Fuse Box
Car charger
Cigarette lighter
1.
Plug the car charger into the car’s cigarette lighter.
2.
Connect the charger’s mini USB connector to the
camera’s mini USB port.
Red wire: Ignition switch (+12VDC input)
Note: Must have voltage during Start and On,
but not ACC. Do not connect to constant 12V
Chassis ground
1.
Connect the red wire of the adapter socket to the fuse box’s ignition switch.
2.
Connect the black wire of the adapter socket to chassis ground.
3.
Plug the car charger into the adapter socket.
4.
Connect the charger’s mini USB connector to the camera’s mini USB port.
Note:
The DC-ACC-CS1Q includes low voltage circuit protection that will shut off the camera if
the battery voltage is less than 11.8VDC.
Car charger
Cigarette Lighter
Adapter Socket
(DC-ACC-CS1Q)
Mounting:
Powering the Camera:
Mounting tab
Power the camera using the included car charger or directly to the fuse box using the optional
cigarette lighter adapter socket. For fuse box connection, professional installation is recommended.
