Charging Method
Automatic constant current / constant potential
Initial Charging Current
2.5 A max.
Charging Voltage
5.3 VDC switching to 5.1 VDC (float mode 4.6 VDC)
Charging Time
Approximately 8 hrs. (after 8 hour discharge)
Supply Voltage
115 / 230 VAC +/- 10%, single phase, 50/60 Hz
Power Consumption
70 WATTS, 500mA fuse
1A for 115 V AC operation
Dimensions
Length:
190mm (7.68 in.)
Width:
120mm (3.94 in.)
Height:
100mm (2.87 in.)
Weight:
1.65 kg (3.6 lbs.)
Technical Data
P
ART NO
.
M656201
115
/
230
V
AC,
SINGLE PHASE
50
/
60
H
Z
SINGLE LAMP CHARGER
CAUTIONS AND
WARNINGS
IMPORTANT
Pay close attention to
Warnings and Cautions in
this manual. A Warning
describes a condition that
may cause serious
personal injury or death if
allowed to happen. A
Caution describes a
condition that may cause
the cap lamp or other
property to be damaged if
allowed to happen.
DESCRIPTION /
INSTALLATION
DESCRIPTION
INSTALLATION
•
The plug (not supplied)
must be changed (or
adapted for
International usage) to
match the mating outlet.
The single lamp charger is
designed to recharge all
type T-type batteries.
The charger is equipped
with a variable rate, factory-
set program controlled by a
micro-processor that
maximizes recharge
capacity in the shortest
amount of time. The charge
indicator is an easy-to-read
LED display; with red and
green lights show the
charge status.
The charger is double
insulated and has a
standard two conductor
cable for connection to the
main power supply.
•
For clarification of plug
type and AC circuit
requirements, please
consult with qualified
electrical power
personnel or standards.
The charger is set for 230 V
AC operation. For operation
from 115 V AC the following
steps must be taken before
charging:
AC Fuse Holder
Voltage Selector Switch (red)
•
The voltage selector
switch underneath the
charger must be set for
115 VAC.
The single lamp battery
charger is also a “float”
charger, which means that
the battery will not be
overcharged if left in charge
mode over long periods of
time.
•
The 500 mA fuse
located adjacent to the
voltage selector switch
must be replaced by the
1A. fuse supplied for
operation at 115v VAC.
