Enerpac ECCE32, Инструкция

Страница: 19 / 24

19
1. Be sure that the cutter piston is fully retracted. If not,
start the cutter and fully retract the piston.
2. Disconnect cutter from AC power supply to prevent
accidental motor start-up during the following steps.
3. Place the cutter horizontally on a stable work surface
with the handle facing upwards.
4. Open the cutter safety guard.
5. Remove the two screws for the lifting eye bracket and
remove the lifting eye bracket.
6. Remove the four screws for the top plate and remove
the top plate.
10.6.3 Blade Replacement - Moving Blade
Replace the moving blade as described in the following
steps. Refer to Figure 16, items 1 through 6.
Figure 16, Moving Blade Replacement
1
3
3
2
4
5
6
Key:
1. Lifting Eye Bracket Screws
2. Lifting Eye Bracket
3. Top Plate Screws
4. Top Plate
5. Retention Pin
6. Moving Blade
7. Remove the retention pin using a pair of pliers.
8. Remove the moving blade from the piston.
9. Install the new moving blade onto the piston and
install the retention pin.
10. Install the top plate, top plate screws, lifting eye
bracket and lifting eye bracket screws. Torque
screws to 18 ft-lbs [25 Nm].
11. Close the cutter safety guard.
12. Test cutter for proper operation before placing it
back into service.