Energie MONOBLOC 100esm, Техническое руководство

Страница: 50 / 92

50
MONOBLOC 100L
English
5.4. Interface with the user
Parameter Description
SP1
Functioning set point of the compressor on ECO mode.
Functioning set point of the compressor and of the resistance on
ObSt
mode if
the ObSt mode is active during the ECO function.
SP2
Functioning set point of the compressor and of the resistance on AUTO mode.
Functioning set point of the compressor and of the resistance on mode if the
ObSt mode is active during the AUTO function.
SP3
Set point to activate “ ObSt ” mode, that is to say, the function will only start when
the water temperature in the thermal accumulator under SP3.
1 - 1 - ON/OFF equipment
Press the key to turn on or turn off the equipment.
Notice: After turning on the equipment you will have 5 min until the equipment begins to
function (compressor’s start-up temporization)
2 - Block/ unblock keyboard
To unblock the keyboard press the key for 4s. The keyboard blocking is automatic and
occurs 30s after any inactivity on the keyboard. When the keyboard blocks this message is
presented on the display for 1s “Loc”.
3 - Information on the display while functioning
While functioning the information presented on the display corresponds to the water’s tem-
perature.
4 - Way of functioning ongoing
To verify the way of functioning ongoing click on the key , automatically will appear
on the display the adopted way.
To change the way of functioning press the key for 2s, with the pointer or
select the way of functioning, after being selected press the key to confirm/
activate the new way of functioning.
5 - Change functioning set point
To change the functioning set point press the key and it will immediately appear on
the display SP1, to change to SP2 or SP3 use the pointers or .
After selecting the parameter you want to change press the key to enter in the pa-
rameter and with the pointers (increase) or (decrease) the parameter value.
To confirm press again the key .
Technical Manual