Energetiq LDLS EQ-1500, Руководство по эксплуатации

Страница: 33 / 44

EQ-1500 Operation Manual Rev 6 27
C h a p t e r 4
OPERATION
Once the lamp is set up properly, verify that all personnel that will be in contact with the lamp
system are aware of the potential hazards involved with its operation. It is the responsibility of
the user to verify that the lamp is being used safely.
To start the lamp:
1. Verify that all safety measures are in place, and that cooling water and purge gas are
flowing.
2. Turn on the main power switch on the back of the unit.
3. The lights on the front panel of the Controller will indicate power and interlock status.
Verify that the following indicators are lit:
- POWER OK
- CONTROLLER INTLK OK
- LAMP HOUSE INTLK OK
- EXTERNAL INTLK OK
4. Push the Operation Selector Switch momentarily up to the LAMP ON position. The
EQ-1500 enters the start mode. While in the start mode, the LASER ON indicators
will light (both on the Controller and the Lamp House). After 60 seconds, the lamp
will ignite and the LIGHT ON indicator will light.
5. If the lamp does not start within approximately 60 seconds, start mode will terminate
(i.e., the lamp stops trying to ignite), and the “Laser Fault” LED will illuminate. If this
happens, push the Operation Selector Switch to OFF / RESET to clear the fault, then
to LAMP ON to try again. [If the lamp still does not ignite after 1 or 2 more attempts,
raise the cooling water temperature to 28°C and try again. Once the lamp ignites,
lower the temperature setpoint back to 22°C for normal operation.]
6. For optimal results (best stability), the EQ-1500 should be allowed to complete a
warmup period of 5 minutes.