3.6V Li-Ion SCREWDRIVER ENS460DRS
Operating instructions
Fig.1
Fig.2
Fig.3
1. INSTALLING AND REMOVING BITS
1.To fit a screwdriver bit, push it into the bit holder until it
locates.
2.To remove a screwdriver bit, pull it straight from the bit
holder.(Fig.1)
Make sure it is fully in place before use.
2. ON/OFF SWITCH
1.Start the tool by squeezing the On/Off Switch(3).
2. Release the switch to stop the machine.
3. SWITCH LOCK
The On/Off switch trigger can be locked in OFF position.
This helps to reduce the possibility of accidental starting
when not in use. To lock the switch, place the
forward/reverse rotation control in the center position.
4.LED WORKING LIGHT
On the head of the tool equipped with LED working light.
You can use the tool in the dark area.(Fig.2)
5. REVERSIBLE
The forward/reverse rotation control located above the
On/Off switch controls the direction of rotation.
For screw driving use forward rotation, slide the rotation
lever to the right. To use reverse rotation, slide the rotation
lever to the left to remove screws or release a jammed drill
bit. (Fig.3)
Warning!
Never change the direction of rotation when the chuck
is rotating, Wait until it has stopped.
6. ROTATION DIRECTION INDICATOR LIGHT
This machine equipped with two direction indicator
light on the top of the tool.(Fig.4)
When the machine with forward rotation, the ahead green
light will illuminate.
When the machine with reverse rotation, the back red light
will illuminate.
Fig.4