3.6V Li-Ion SCREWDRIVER ENS460DRS
CHARGING PROCEDURE
1. BEFORE USING THE SCREWDRIVER
If the machine is new, the battery must first be charged.
A new battery or one which has not been used for an extended period achieves full performance only after few
times charging and discharging cycles.
Attention!
After storing for a long time, the battery capacity will be reduced.
A substantial drop in operating period per charge indicates that the battery is worn out.
Warning!
The charger and battery are specifically designed to work together so do not attempt to use any other devices.
Never insert or allow metallic objects into charger or battery connections because an electrical failure and
hazard will occur.
2. TO CHARGE THE MACHINE
The power voltage supply must conform to that specified on the rating plate of the charger.
Always inspect the battery charger, cord and plug for signs of damage before use.
Connect the battery charger to the power supply and the red Indicator Light (5) will illuminate to show charging
has started. A discharged battery at normal ambient temperature will take approximately 3-5 hours to reach full
charge. When charging is completed the green light will illuminate to indicate end of charge.
ALWAYS disconnect the charger from the power source when it is not in use.
Note:
Red Light = charging
Green Light = charging complete
Warning!
When battery charge runs out after continuous use or exposure to direct sunlight or heat, allow time for the
tool to cool down before re-charging to achieve the full charge.