24V COMBI DRILL ENF464COM
6. SWITCH LOCK
The On/Off switch trigger can be locked in OFF position.
This helps to reduce the possibility of accidental starting
when not in use. To lock the switch, place the
forward/reverse rotation control in the center position.
(Fig.4)
7. REVERSIBLE
The forward/reverse rotation control located above the
On/Off switch controls the direction of rotation.
For drilling and screw driving use forward rotation, slide the
rotation lever to the right. To use reverse rotation, slide the
rotation lever to the left to remove screws or release a
jammed drill bit.
(Fig.5)
Warning!
Never change the direction of rotation when the chuck
is rotating, Wait until it has stopped.
8. TWO-SPEED GEAR CONTROL
The drill has a two-speed gear control designed for drilling
or driving at low (mark is 1 0-400/min) or high (mark is 2
0-1150/min) speeds. A slide switch is located on top of the
drill for selecting. When using the drill in the low speed
range, the speed will decrease and the drill will have greater
power and torque. When using the drill in the high speed
range, the speed will increase and the drill will have less
power and torque. (Fig.6)
Warning:
To prevent gear damage, always allow the chuck to
come to a complete stop before changing the direction
of rotation or the two-speed gear control.
9. TORQUE ADJUSTMENT
(Screw driving force of your combi drill)
The torque is adjusted by rotating the torque adjustment
ring. The torque is greater when the torque adjustment ring
is set on a higher setting. The torque is less when the torque
adjustment ring is set on a lower setting. Rotate the torque
adjustment ring to the desired setting (Fig.7)
1-4: For driving small screws
5-8: For driving screws into soft material
9-12: For driving screws into soft and hard material
13-16: For driving screws into hard wood
17-20: For driving larger screws:
For drilling:
For hammer drilling in masonry and concrete
Fig.5
Fig.6
Fig.7
Fig.4
