24V COMBI DRILL ENF464COM
TERMS OF USE
When all precautions have been taken and the previous operations were done, you can start working.
Always secure the work piece especially if it is small and the sheets.
Use the appropriate drill bit and the material at the correct speed.
In the woods, a burned area indicates an inappropriate speed or a bit sharpened improperly.
In steel, lubricate to prevent overheating and premature wear of the drill.
In the lightweight construction materials use the maximum speed limit and put a great effort all the more
that the bit is large.
Stay in the extension of the machine, perpendicular to the surface to be drilled.
In the steel it is recommended to leave the drill regularly to remove chips and cool the drill.
The stress on the machine should not be such that the speed is reduced by more than 25% for significant
periods. When overloaded passenger, run the machine empty for 3 to 5 minutes to cool the engine.
When screwing, use the tip perfectly adapted to the screw head on pain of not being able to tighten the
screws or damage. Use speed and minimum torque to start and perform tests, and the couple can then
be adjusted.
CARE AND MAINTENANCE
Disconnect the battery from the tool before making any adjustments or maintenance.
This machine requires no special mechanical maintenance such as greasing the bearings.
Do not try to open or disassemble your drill or feeder to intervene yourself. Do not open and replace the
battery cells.
Do not let the drill dead load.
Make sure the battery pack is suitable for the tool and is charged using the correct charger
recommended. Improper use may cause risk of electric shock, overheating or leakage of electrolyte. To
protect the batteries from damage, do not expose to temperatures above 4
0℃
Cleaning of plastic parts is unplugged charger and battery removed, using a soft damp cloth and a mild
soap.
Never immerse the machine and do not use detergent, alcohol, gasoline, etc..
In case of problems or for a deep cleaning, consult the manufacturer, its service agent or a similarly
qualified person to avoid a hazard.
If the power cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
