04
05
ENB520GRB by
Energer
ENB520GRB by
Energer
Technical and legal
information
Your product
Your product
GB
IE
Getting started...
GB
IE
Getting started...
Technical data
1
2
3
4
5
6
1. Water container
2. Wet-Grinding disc
3. Spark guard
4. Dry grinding disc
5. Workpiece support
6. On/off switch
>Voltage :230V-240V ~50Hz
>Rated input :250 W, S2:30min
>Idling speed of wet-Grinding disc :134min-
1
>Idling speed of dry-Grinding disc :2950min-
1
>Protection glass : I
>Degree of protection : IP20
>Dimensions Wet-Grinding disc :Ø200x40xØ20mm
>Dimensions Dry-Grinding disc :Ø150x20xØ12.7mm
>Coarse wheel grit :#36
>Medium wheel grit :#60
>Weight :8.5kg
Noise data
>Sound power level (L
W
A*) :62.6dB(A)
>Uncertainty KpA :3dB
>Noise pressure level (L
P
A*) :75.6dB(A)
>Uncertainty KwA :3dB
Vibration level :2.5 m/s
2
Uncertainty K :1.5m/s
2
W A R N I N G : When using electric tools basic
safety precautions should always be followed to
reduce the risk of fire, electric shock and personal
injury including the following.
Read all these instructions before attempting to
operate this product and save these instructions.
The declared vibration total value has been measured in accordance with a
standard test method and may be used for comparing one tool with another.
The declared vibration total value may also be used in a preliminary assessment
of exposure.WARNING: The vibration emission during actual use of the power
tool can differ from the declared total value depending on the ways in which the
tool is used. The need to identify safety measures and to protect the operator are
based on an estimation of exposure in the actual conditions of use (taking account
of all parts of the operating cycle, such as the times the tool is switched off, when it
is running idle, in addition to trigger time).
Load factor:
A load factor of S2 30 min(temporary duty)means that you may operate the
motor continuously at its nominal power level (250W) for no longer than the
time stipulated on the specifications label (30minutes ON period). If you fail to
observe this time limit the motor will overheat. During the OFF period the motor
will cool again to its starting temperature.
