18
19
Care and maintenance
Wet grinding wheel replacement
GB
IE
GB
IE
In more detail...
ENB520GRB by Energer
ENB520GRB by Energer
In more detail...
Care and maintenance
Clean water container
> Allow the water to drain out of the water container.
> Disassemble the water container from the housing.
– Loosen the nut (1) and together pull using tightening flange (2).
– Now, pull the cutting edge (3) from the motor shaft.
The rear tightening flange remain on the motor shaft.
Installation in reverse order.
– Slightly grease the metal parts to prevent corrosion.
1
2
3
WARNING!
Risk of injury! It is possible to slide the new cutting disc easily on
the motor shaft. Because of danger of breaking, the cutting disc
must not raise by force e.g. by hammer blows in any circumstances
or drill too small receiving holes.
Replace water in the water container
> Replace water in the water container regularly, since grinding swarf in the water may
influence the grinding result negatively.
> For this, hold a collecting tray under the drain outlet of the water container.
> Pull the rubber plugs (1) out of the drain outlet and let the water drain off.
> If possible, remaining grinding swarf with clean water in the water container.
> Insert again the rubber plugs (1) into the drain outlet.
1
2
> Fill the water container with clear water up to 1/3 of the cutting disc diameter (2).
> Thoroughly clean the water container from time to time to remove stubborn
grinding swarf.
> For this loosen both the screws (1) in the housing and pull the water container
down.
> Clean the container internally with clear water and brush (no metal bristles!).
> Re-assemble the water container in the housing and fill with clear water up to
approx. 1/3 of the cutting disc diameter.
1
